FAQs | Find Answers

Search Results

Results 71 - 80 of 92

Recommended Links
  1. LinkStation 400 - How to Configure FTP Server
    [Answer ID: 15143]
    By default, the LinkStation's shares are only accessible by users connected to the same network or routers as the LinkStation.The optional FTP server allows users outside the local network to access the LinkStation....
  2. LinkStation 400 - How do I set a fixed (static) IP address for the LinkStation?
    [Answer ID: 15144]
    Normally, the LinkStation's IP address is set automatically from a DHCP server on your network. If you prefer, you can set it manually. To change the LinkStation's IP address settings, your computer should be connected to the same router (subnet) as the LinkStation and should be running NAS Navigator2....
  3. LinkStation 400 - Online Update
    [Answer ID: 15145]
    If a new firmware is available, a message is displayed when the LinkStation boots. You can update the firmware by the following way: 1.In Advanced Settings, click [Management]. How to Open Settings...
  4. LinkStation 420, 421e - How can I replace a hard drive and rebuild a RAID array in the LinkStation?
    [Answer ID: 15146]
    If a drive fails, NAS Navigator2 and Settings will show an error message.Follow this procedure to replace a failed hard drive with a Buffalo Technology OP-HD/LS series drive of the same size or larger capacity(*), available from www.buffalotech.com....
  5. TeraStation 5000 - Using JBOD
    [Answer ID: 15159]
    With JBOD, each hard drive in the TeraStation is addressed separately. To put drives from an array into JBOD mode, follow the steps below.1.In the TeraStation's settings, click to the right of "RAID"....
  6. How to Open Settings
    [Answer ID: 15163]
    Configure and administer your TeraStation using the settings interface, accessible from a browser window. Open the interface using the procedure below or type the TeraStation's IP address in the URL field of your browser. Within Settings, the Easy Admin page gives you quick access to commonly used settings....
  7. LinkStation 400 - You can't see the contents from a DLNA-compatible device
    [Answer ID: 15167]
    If you remove the USB drive without properly dismounting it, you may not see the contents from a DLNA-compatible device, even if you reboot the LinkStation.In such a case, wait for 50 seconds, then follow this procedure to connect a USB drive to a USB port on the LinkStion again and dismount the drive properly....
  8. Surveillance Cameras Troubleshooting
    [Answer ID: 15170]
    IssuePossible CausePossible SolutionVideo recording does not start.Surveillance Camera setting not enabled.Enable the Surveillance Camera from Settings.A LAN cable between the TeraStation and network camera is disconnected, or the power is turned off....
  9. TeraStation 7000 – How to replace a hard drive and rebuild a RAID array in the TeraStation?
    [Answer ID: 15184]
    Hard drives in the TeraStation show a blue status LED during normal operation. When a drive fails, its error LED will glow red. A failed drive whose error LED is glowing red may be hot swapped....
  10. How to Update the Effective Date of NovaBACKUP License
    [Answer ID: 15191]
    Go to the http://www.novastor.com/en/upgrade website to update the effective date of NovaBACKUP license of an OP-LP-NOVA/PRO or OP-LP-NOVA/BE license pack. Enter the License key ("Key Code") from the sheet "NovaBACKUP License Pack GUIDE" and the email address, then click [Enter]. You will get new license key....
< Previous  2  3  4  5  6  7  8  9  10  Next >

Refine your search

Select Product / OS & Hardware

      Enter Keywords or a specified ID